|
Post by chuck62 on May 12, 2011 9:29:58 GMT -5
Happy Birthday BenHowerd. Looks like dirt just got older. You still go that DAP?
|
|
|
Post by benhoward#42 on May 13, 2011 16:55:40 GMT -5
Ya Chuck.. also hear you ended up with "THE" Sudam.. thanks for the B-Day wishes..
|
|
|
Post by gokarr65 on May 13, 2011 22:05:56 GMT -5
I will second that! , hope it was a good one .
|
|
|
Post by chuck62 on May 15, 2011 9:35:10 GMT -5
Ken you still got that DAP? If we can find the parts to make it run. I will by it. But need to know that I can find all the parts. I.E belt driver/ Intake/ Header.
|
|
|
Post by benhoward#42 on May 15, 2011 21:46:39 GMT -5
Still have the DAP.. I have a couple of flanges for making a header that I bought from Keith @ Margay.... It has an intake to bolt a 24mm carb to, like a Tillotson 360/IBEA/Tryton/etc.... and I have a 20 tooth Hegar type 3-peice driver made by Elmer for my Italsistem that will fit.. DAP/Italsistem have the same taper(6°).. as D'Angelo and Achille Parilla were brothers..they made their stuff a little different than IAME..
I also have #219 chain drivers(9,10 tooth) with that taper if you might consider using an axle clutch instead of the jackshaft setup(have 2 Horstman and 1 SMC available)
Call me and I can make you a package with the extra parts for a good deal.. and you can find an old reedjet header to cut off and re-weld to the DAP flange(I think I even have one of them).. maybe you would be interested in Jason Gibbs ex- SV21E Italsistem front belt driven rotory too.. rare and fresh.. 50.10 green dot piston done by Mckenna.. package deal.
Need any chassis? Have two 2007 Buller Velocity's available w/Gibb or Buller wedges.. 360-348-1377 Ken
|
|